Ethernet - D-Link DSL-2888A User Manual

Section 4 - Configuration
Your DSL-2888A is equipped with a Gigabit Ethernet WAN port which can be used to connect
to the Internet. This port may be used to connect to other Ethernet based networks. In
order for your DSL-2888A to use Ethernet you must configure the Ethernet Settings, VLAN
Settings, and your IPv4/IPv6 Settings.
Select Residential Gateway to configure Ethernet connection
WAN Access Type:
settings.
Interface: Select the interface from the drop-down menu. ETH0-ETH5 are
available. The default is ETH0.
Enable Interface: Select whether to enable or disable this interface.
VLAN Settings
VLAN Tagged:
Enable or disable VLAN tagging.
If you enabled VLAN Tagged, the following options are available:
VLAN ID:
Enter the VLAN ID. The value should be 0, or 0-4079.
VLAN Priority:
Enter the VLAN Priority from the default 0 (lowest) to 7 (highest).
Proceed to IPv4 Settings on page 32 or IPv6 Settings on page 36.
D-Link DSL-2888A User Manual

Ethernet

DSL-2888A HW:V1.0.0 FW:V1.1.43
Settings >> Internet
ISP SETTINGS
Home Settings Features
Internet
Use this section to configure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
DSL Profile Priority
⌵
WAN Access Type: Residential Gateway
⌵
Interface: Eth 0
Enabled
Enable Interface:
VLAN Tagged: Enabled
VLAN ID:
⌵
VLAN Priority: Disable
Management
Save
30