Pppoe - D-Link DSL-2888A User Manual

Section 4 - Configuration
Select PPPoE if your ISP provides and requires you to enter a PPPoE username and password
in order to connect to the Internet.
IPv4 Settings:
My Internet Select PPPoE.
Connection is:
Username: Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Reconnect Mode: Select either Always-on, On-Demand, or Manual.
Advanced Settings
Select Static IP if your ISP assigned you an IP address, subnet mask,
Address Mode:
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP address provided by your ISP. Static IP only.
Service Name: Enter the ISP service name (optional).
Primary DNS Enter the primary DNS server IP address assigned by your ISP. This
Server:
address is usually obtained automatically from your ISP.
Secondary DNS
Enter the secondary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Enable NAT:
Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 36 or click Save when you are done.
D-Link DSL-2888A User Manual

PPPoE

IPv4 SETTINGS
⌵
My Internet Connection is: PPPoE
Username:
Password:
⌵
Reconnect Mode: Always On
⌵
Address Mode: Dynamic IP
Service Name:
Primary DNS Server:
Secondary DNS Server:
⌵
MTU: Auto
Enabled
Enable NAT:
⌵
Address Mode: Static IP
IP Address:
Service Name:
Primary DNS Server:
Secondary DNS Server:
⌵
MTU: Auto
Enabled
Enable NAT:
Advanced Settings ...
34