Usb - D-Link DSL-2888A User Manual

Section 4 - Configuration
The DSL-2888A supports USB mobile broadband adapters. You can connect a mobile
broadband adapter and share your cellular network connection with your home network.
For a list of supported adapters, visit www.dlink.com.
This page provides configuration settings for your USB mobile broadband connection.
Refer to your mobile broadband adapter's documentation for setup instructions and ISP
for configuration information. In most cases, the process is plug and play and requires no
further configuration.
Select USB to configure USB connection settings.
WAN Access Type:
Interface: Select the interface from the drop-down menu.
Enable Interface: Select whether to enable or disable this interface.
ISP Settings
Country:
Select your country.
ISP:
Select your ISP. A number of ISP configuration settings are pre-
programmed into the DSL-2888A for convenience. If you don't see
your ISP or wish to use manual settings, choose Not Listed.
PIN Code:
Enter your PIN code.
Dial Number: Enter the Dial Number.
APN: Enter the APN.
Username: Enter your username.
Password: Enter your password.
There is no further configuration. Click Save when you are done.
D-Link DSL-2888A User Manual

USB

DSL-2888A HW:V1.0.0 FW:V1.1.43
Settings >> Internet
ISP SETTINGS
Home Settings Features
Internet
Use this section to configure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method, please
contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or disable
any PPPoE client software on your computers.
DSL Profile Priority
⌵
WAN Access Type: USB
⌵
Interface: USB 0
Enabled
Enable Interface:
⌵
Country: New Zealand
⌵
ISP: Not Listed
PIN Code:
Dial Number:
APN:
Username:
Password:
COPYRIGHT © 2016 D-Link
Management
Save
31