Pppoe - D-Link Go-RT-N300 User Manual

N300 wi-fi router

Table of Contents

Section 3 - Configuration

Select PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username

and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The

software is no longer needed and will not work through a router.

User Name:

Enter your PPPoE user name.

Password:

Enter your PPPoE password.

Service Name:

Enter the ISP Service Name (optional).

Idle Time:

Enter a maximum idle time during which the Internet connection

is maintained during inactivity. This option is only available if

Connection Type is set to 'Connect on Demand' .

MTU Size:

Maximum Transmission Unit - you may need to change the MTU for

optimal performance with your specific ISP. 1492 is the default MTU.

Static IP Address:

Enter the static IP address only if assigned by your ISP.

Select Continuous (most common) to have the router constantly

Connection Type:

connected to your ISP, Connect on Demand to have the router

connect to the Internet when you initialize a connection, or Manual

if you want to manually connect/disconnect to the Internet.

Attain DNS

Select if you automatically receive the DNS server(s) from your ISP

Automatically:

(enabled by default).

Set DNS

If you want to enter your own DNS server IP addresses, select this

Manually:

and enter the IP address(es) in the DNS Server 1 and 2 boxes.

WAN port rate:

Select the Internet port speed from the drop-down menu.

D-Link GO-RT-N300 User Manual

PPPoE

Table of Contents