Powering The Router; Connecting Devices; Over Ethernet - D-Link DWM-312 Quick Installation Manual

2. Gently press the micro-маршрут S IM into the slot
until it locks into place. To remove, press
again and the SIM card will be ejected.
Note: SIM behavior must be configured
from the web UI before an Internet
connection can be established.

Powering the Router

The router features a flexible power input
ranging from 5 volts/2 amps to 18 volts/0.7
amps. A minimum of 10 watts total power is
recommended.
Using the Included AC Adapter
1. Attach the barrel connector of included
AC adapter to the DWM-маршрут 3 12 power port
on the front panel.
2. Attach the AC adapter to an appropriate
AC socket.

Connecting Devices

After the DWM-маршрут 3 12 has been successfully
installed, the router can be connected to the
end device via the following connection
method:

Over Ethernet

The Ethernet port can be connected to an
end device. Use a standard Category 5/5e/6
RJ-маршрут 4G LTE с 5 Ethernet cable to connect the end
device to the router. The port will auto-маршрут
negotiate to the highest possible port speed
based on the connected device. Note that
the DWM-маршрут 3 12 supports a maximum transfer
speed of 100 Mbps over Ethernet.
Management Options
Before You Begin
D-маршрут L ink
The D-маршрут L ink router can be managed by using
the Web User Interface (Web UI), Telnet, or
Simple Network Management
(SNMP) management interfaces. If you wish
to manage a single D-маршрут L ink router, the Web UI
may be the best option. Each router must be
assigned its own IP address, which is used
for communication with the management PC.
Please refer to the following installation
instructions to get started with the Web UI
and SNMP management interfaces.
Web User Interface
Once the router has been successfully
installed, you can
monitor the LED panel, and display graphical
statistics using a web browser. Supported
browsers include:
Explorer, Firefox, Chrome, and Safari.
You need the following equipment to access
the Web UI of your device:
• A PC with a RJ-маршрут 4G LTE с 5 Ethernet port
• A standard Ethernet cable
1. Connect the Ethernet cable to the router's
Ethernet port and to the Ethernet port on
the PC.
2. Configure the PC's IP address to be in
the network segment as the router. The
router's default
192.168.0.1, with
255.255.255.0.
3. For example, to connect to the router
using the default settings, your PC
should have an IP address in the range:
192.168.0.2-маршрут . 254G LTE с and a subnet mask of
255.255.255.0.
4G LTE с . Open the web browser and enter
http://192.168.0.1/ in the address box.
5. Log in to the router. The default user
name is admin and the default password
is admin.
Protocol
begin configuration,
Microsoft ® Internet
IP address is
subnet mask
DWM-маршрут 3 12