Web Browser Control - visual engineering PAL/NTSC H.264 Encoder User Manual

PAL/NTSC H.264 Encoder

Web Browser Control

The primary mechanism for controlling the encoder is its web browser interface.
The example screen below shows what is to be expected once a valid connection between the PC
and encoder/camera has been established by typing the encoder's IP address into the web browser
address bar. In this example it is the default address of 192.168.1.195
The video can be seen in the Video Panel window. If no image is seen ensure the video plug-in for
the web browser is enabled and refresh the web page.
On the left side of the screen are the Control Menus which allow the user to configure various
setting in the encoder. The functions of these menus are described in the following sections of this
user guide.
Control Menus
visualengineering.co.uk
Visual Engineering
Video solutions. Integrated
The encoder's IP address is typed in here.
In this example the IP address is
192.168.1.195
Video Panel Window.
If no image is seen, enable the video
plug-in and refresh the web page.
December 2016
Page 13