Changing To A Size That Is Not Automatically Detected - Ricoh pro c901 Troubleshooting Manual

9. Tightly fit the end fence to the loaded paper, and then re-lock the end fence again.
10. Carefully slide the paper tray fully in.
11. Check the size on the display.
• p.46 " Loading small size paper into the Wide Large Capacity Tray"

Changing to a Size That Is Not Automatically Detected

This section describes how to set the paper size that is not automatically detected.
When paper is loaded which cannot be detected automatically, the user must set the paper size on the
control panel.
1. Press the [Paper Setting] key.
2. Select the tray number on the screen.
3. Press [Paper Size] tab.
4. Select the loaded paper size and feed direction, and then press [OK].
5. Press the [Paper Setting] key.
CAL064
CAL166
Changing the Paper Size
69
2