Adding Paper, Toner, Staples, Rings And Glue; Loading Paper; Loading Paper Into Tray 1 (Tandem Tray) - Ricoh pro c901 Troubleshooting Manual

2. Adding Paper, Toner, Staples, Rings
and Glue
This chapter describes how to load paper, add toner or replace staples and other consumables.

Loading Paper

This section describes how to load paper into the paper tray.
• When loading paper, take care not to trap or injure your fingers.
1
Tray 1 uses 8 / " × 11" exclusively. Load only 8
2
• Fan the paper before loading.
• Straighten curled or warped paper before loading.
• For details about paper sizes and types, see "Recommended Paper Sizes and Types", About This
Machine.

Loading Paper into Tray 1 (Tandem Tray)

This section describes how to load paper in Tray 1.
• When paper loaded in the right side of Tray 1 runs out, paper on the left is automatically shifted to
the right. While the paper is moving, a message instructing you to wait appears. Do not pull out the
tray at this time.
• You can load paper even while making prints from Tray 1. You can pull out the left side of Tray 1
while printing is in progress.
• For the right side of Tray 1, align the right edge of the paper with the right edge of the tray. For the
left side of Tray 1, align the left edge of the paper with the left edge of the tray.
1
• Tray 1 uses 8 / " × 11" paper. If you want to load A4 paper, contact your service representative.
2
• You can load up to 1,100 sheets of paper on each side. Do not stack paper higher than the limit
mark.
1
/ " × 11" paper at all times.
2
2
39