Table of Contents
Advertisement
Version 1.05
5.8
Setup Menu
5.8.1 QNH
Under this page, the pilot can change the QNH setting. If QNH setting is correct, NANO
show correct altitude.
Wrong QNH setting will have effect only on wrong altitude warnings and wrong
final glide calculation. QNH setting has no influence over the recorded altitude in
the IGC file
5.8.2 Flight recorder
Under this page; flight recorder, pilot information and glider data are configured.
Pilot name must be entered here
Co-Pilot name must be entered here, if glider is double seater.
Competition sign of glider
Registration of glider
Recording interval sets the interval when the GPS position will be stored in flight
Auto Finish will allow the automatic finish of the flight, under certain conditions.
Uncheck this item for wave flying. (ground speed is used to indicate the end of a
flight and in wave it is possible to be stationary or even fly backwards in relation to
the ground)
Auto Off will power off the NANO
Logger always on will force the logging/write position to an IGC file immediately
after power on. Normally the NANO
40km/h or vario over 1m/s. This function is recommended to be enabled only for
hang gliders.
Pilot weight
CoPilot weight
4
30 minutes after the flight is finished
4
logger is triggered by ground speed exceeded
Page 29 of 54
May 2017
4
will
Advertisement
Table of Contents
