Table of Contents
Advertisement
48 | Flue gas test
12
Flue gas test
12.1
Emissions test button
The following appliance outputs can be selected by pressing the
emissions test button
until it lights up:
3
4
2
5
1
6
max
Fig. 62 Press the emissions test button
•
= Maximum set output in heating mode ( Maximum heating
output, page 40)
•
= maximum nominal output
•
= Minimum nominal output
You have 15 minutes to complete the tests. After that, the appliance
returns to default mode.
12.2
Measuring CO content of flue gas
Use a multiport flue gas probe for the measurements.
▶ Remove plug from flue gas test port ( Fig. 56, page 46 ).
▶ Insert the flue gas probe approx. 2-3/4 inches (70 mm) into the test
port and seal around it.
▶ Press the emissions test button to select
output.
▶ Measure the CO levels.
DANGER:
Risk of flue gas poisoning.
The CO level in the flue gas must be below 200 ppm (air free).
1)
▶ If 9.4 Vol.%
CO
and a CO level under 200 ppm (af) can not be
2
achieved due to the gas supplied, use a lower CO
emissions under 200 ppm (af) instead.
▶ Repeatedly press the emissions test button
out.
The display returns to the supply temperature.
▶ Remove the flue gas probe and seal the flue gas test port properly
( Fig. 60, page 47).
1) 9.4 Vol.% with NG and 11.0 Vol.% with LPG (propane)
6720872361 (2017/04)
reset
eco
3
4
e
2
6
1
min
max
6 720 641 933-51.1O
= maximum nominal
level with CO
2
until the light goes
13
Environmental protection and disposal
Environmental protection is one of the fundamental company policies of
the Bosch Group.
Quality of products, efficiency and environmental protection are equally
important objectives for us. Environmental protection laws and
regulations are strictly adhered to.
To protect the environment, we use the best possible technology and
materials taking into account economic points of view.
Packaging method
For the packaging, we participate in the country-specific recycling
systems, which guarantee optimal recycling.
All packaging materials used are environmentally-friendly and
recyclable.
Old appliances
Old appliances contain valuable materials that can be recycled.
The components are easy to separate. Plastics are identified. This allows
the various assemblies to be sorted and recycled or disposed of.
14
Inspection and maintenance
Regular service and maintenance are recommended for a long service
life of the appliance, for efficient and economical operation, and to keep
the environmental impact as low as possible.
DANGER:
Explosion!
▶ Close the gas cock prior to working on the gas train.
▶ Check for gas leaks after carrying out work on the gas train.
DANGER:
Risk of flue gas poisoning.
▶ Check for leaks after carrying out work on the venting system.
DANGER:
Risk of electric shock!
▶ Always disconnect the appliance from the mains power before
performing any work. Always disconnect the appliance from the
mains power before performing any work. Take measures to prevent
accidental reconnection.
NOTICE:
Insufficient antifreeze can accelerate corrosion.
▶ Frost protection level has to be checked annually during the regular
scheduled maintenance of the condensing boiler.
Greenstar combi 100 p / 151 p
Hide quick links:
Advertisement
Table of Contents
