Pre-Installing Pipes - Bosch Greenstar combi 100 p Installation And Service Instructions For Contractors

Household sources
Cleaning and Perchloroethylene, methylchloroform,
degreasing agents trichloroethylene, methylene chloride, carbon
tetrachloride, hydrochloric acid
Workshop
Solvents and thinners Various chlorinated hydrocarbons
Aerosols Chlorofluorinated hydrocarbons
(difluorodichloromethane)
Table 10 Corrosive materials
Surface temperature
The max. surface temperature of this appliance is below 185 °F (85 °C).
According to ANSI/Z223.1/NFPA54 (National fuel gas code) and CAN/
CGA B 149.1 (Natural Gas and Propane installation code), the appliance
is approved for zero clearance to combustibles. For servicing a clearance
of 4" (102 mm) is recommended.
6.4

Pre-installing pipes

▶ Secure the installation template supplied with the technical
documentation to the wall; when doing so, observe the minimum side
clearances of 4 inches (102 mm) (  page 7).
▶ Drill holes for the appliance and for the hydraulics connection plate in
accordance with the mounting template.
( 17 11/1 8 in. ) ( 17 11/1 8 in. )
Fig. 11 Mounting template
NOTICE:
For walls with insufficient load capacity, the appliance and the
hydraulics connection plate must be mounted on a sheet of plywood or
similar reinforcement.
Greenstar combi 100 p / 151 p
Notes on installation and operation | 21
▶ Remove the mounting template.
NOTICE:
The hydraulics connection plate (packed in cardboard) can be found in
the air box of the appliance.
▶ Secure the hydraulics connection plate and the mounting bracket
with the mounting kits supplied.
Fig. 12 Installing the hydraulics connection plate
7 7/8"
(200 mm)
=
1 2
Fig. 13 Hydraulics connection plate (front view)
[1] Heating supply, R 1" NPT
[2] DHW, R 3/4" NPT
[3] Gas, R 3/4" NPT
[4] Cold water, R 3/4" NPT
[5] Heating return, R 1" NPT
0010014680-001
=
3 4 5
6 720 641 933-90.1O
6720872361 (2017/04)