Heatline SARGON 18S Installation, Servicing And User Instructions Manual page 36

18.5 Printed Circuit Board (PCB)
• Read the notes at the head of this section before commencing any work on the
appliance.
• Remove interface cover by lifting the two latches. (fi gure 34)
• Access the main PCB by opening the PCB cover.
• NOTE the location of each plug before removing the electrical connections from
the PCB by releasing the clips and carefully pulling off the connectors.
• Release the 4 screws securing the PCB to the control panel and lift out the PCB
• Fit the replacement PCB in reverse order of removal, ensuring that the PCB electrical
connections are correctly located and fully pushed home.
18.6 Pump
• Read the notes at the head of this section before commencing any work
on the appliance.
• The order of removal is dependant on whether it is
the motor or body that has failed.
In case of motor failure:
• Disconnect the screws connecting the pump head to the body, fi gure 35.
• Pull off the pump head and disconnect the electrical connection from the cable
connection box of the pump, fi gure 36.
Figure 35
Figure 34
Figure 36
32