Footboard Converter Xlt Max - Invacare XLT User Manual

XLT
Adjusting the angle
A
Pull the lever A with one hand while supporting the legrest with
1.
your other hand.
2. When a suitable angle is obtained, let go of the lever and the
legrest will look into one of seven preset positions.
WARNING!
Risk of catching the ground
– The distance between the lowest part of the footrest
and the ground must be at least 40 mm.
IMPORTANT!
Risk of damage to the mechanism
– Do not place anything heavy, or let children sit on
the legrest.

3.8 Footboard converter XLT Max

The footboard converter is a sturdy construction in three parts
that is easily disassembled to allow for transfers into and out of the
wheelchair.
IMPORTANT!
– Make sure that the feet are placed as far out as
possible before the middle part is installed or removed.
Otherwise the pressure on the footplates might cause
the footboard to break.
10
Removing
B
CAUTION!
Risk of pinching
When handling the footboard there is a risk of pinching
your fingers.
– Make sure that no pressure is on the footboard when
it is being handled and adjusted.
IMPORTANT!
– Make sure that the feet are placed as far out as
possible.
Press button A.
1.
Slide the right-hand side footplate B sideways.
2.
3. Press button C and remove the middle part.
Installing
B
A
WARNING!
Risk of injury
If the middle part is not installed correctly it will fall out
and the user can get hurt.
– The buttons A must pop out when the middle part is
installed correctly and turned the right way.
1. Install the middle part of the footboard converter by inserting the
fasteners into one of the footplates and then on the other side.
A small marking (hole) on the part should be facing
backwards B (towards the wheelchair) when the footboard
is assembled correctly.
A
C
A
1512799-A