Required Tools And Equipment; Hand Tools; Equipment - Cisco ASR 5000 series Installation And Administration Manual

Installation Procedure Overview

Required Tools and Equipment

This section lists the tools and equipment needed for installation.

Hand Tools

The following hand tools are required for installation of the chassis, application and line cards, fan tray assemblies, and
power filter units:
Phillips screwdriver #2 and #1. Used to tighten thumb-screws on cards, fan tray assemblies, PFUs, and mounting
brackets.
9/16-inch nut driver or ratchet and socket set. Used to connect power and return cables.
3/8-inch nut driver or ratchet and socket set. Used to connect grounding cables.
Grounding wrist and/or heel straps. Used to prevent Electro-Static Discharge (ESD) as discussed in the
Protecting Against Electro-static Discharge section that follows.

Equipment

The following equipment is necessary to install the chassis and verify that it is ready for configuration:
Standard 19-inch (48.26 cm) equipment rack or telecommunications cabinet with mounting hardware
DC power supply capable of providing the following:
Console cable supplied with the Switch Processor I/O (SPIO) line card.
A computer or terminal server with a 9-pin RS-232C serial port, or 25-to-9-pin male RS-232C adapter. Used to
connect to the SPIO's Console Port for accessing the Command Line Interface (CLI) for system configuration.
OL-24878-01
ESD C :
AUTION
During installation, maintenance, and/or removal, wear grounding wrist
and/or heel straps to avoid ESD damage to the components. Failure to do so could result in damage
to electrical components and could potentially void your warranty.
Important:
Additional hardware, such as extension brackets, may be used to install the
chassis in a standard 23-inch (58.42 cm) cabinet or rack.
Between -40 and -60 VDC @ 130 A for the ASR 5000 chassis.
Cisco ASR 5000 Series Aggregation Services Router Installation and Administration Guide ▄
Required Tools and Equipment ▀