Standards Compliance - Cisco ASR 5000 series Installation And Administration Manual

▀ ASR 5000 Line Cards
Number Description
6 Line Card Label—Identifies the type of SFP modules and cabling supported:
STM-1
OC-3
SM IR-1
STM-1
OC-3
Multi-Mode
CLC2
OC-3/STM-1
Single Mode
CLC2
OC-3/STM-1
Multi-Mode

Standards Compliance

The Channelized Line Card (CLC) was developed in compliance with the following standards:
ITU-T - Recommendation G.704 - Synchronous Frame Structures Used at 1544, 6312, 2048, 8448 and 44736
kbit/s Hierarchical Levels, October, 1998.
ITU-T - Recommendation G.706 - Frame Alignment and Cyclic Redundancy Check (CRC) Procedures Relating
to Basic Frame Structures Defined in Recommendation G.704, April 1991.
ITU-T - Recommendation G.707 Network Node Interface for the Synchronous Digital Hierarchy (SDH),
December 2003.
ITU-T - Recommendation G.747 Second Order Digital Multiplex Equipment Operating at 6312 kbit/s and
Multiplexing Three Tributaries at 2048 kbit/s, 1993.
ITU-T - Recommendation G.751 Digital Multiplex Equipment Operating at the Third Order Bit Rate of 34 368
kbit/s and the Fourth Order Bit Rate of 139 264 kbit/s and Using Positive Justification, 1993.
ITU-T - Recommendation G.775, - Loss of Signal (LOS) and Alarm Indication Signal (AIS) Defect Detection
and Clearance Criteria, November 1994.
ITU-T - Recommendation G.783 Characteristics of Synchronous Digital Hierarchy (SDH) Equipment Functional
Blocks, February 2004.
ITU-T - Recommendation G.823, -The Control of Jitter and Wander within Digital Networks which are based on
the 2048 kbit/s Hierarchy, March 2000.
ITU-T - Recommendation G.824 The Control of Jitter and Wander within Digital Networks which are based on
the 1544 kbit/s Hierarchy, March 2000.
▄ Cisco ASR 5000 Series Aggregation Services Router Installation and Administration Guide
ASR 5000 Hardware Platform Overview
OL-24878-01