Cisco ASR 5000 series Installation And Administration Manual page 80

▀ Installing the Chassis
Step a
on the sides of the bezel and pulling it toward you. Place it to the side for re-installation later.
Step b
screwdriver and pulling it away from the chassis.
Step c
Place it to the side for re-installation later.
weight from its front and back as you slide it completely out of the chassis. Vorsicht beim Herausziehen der
Luefter-Schublade: um eine Beschaedigung des Moduls und eventuelle Verletzungen zu vermeiden, sollte
diese hinten und vorne unterstuetzt werden.
Step 3
Remove the PFUs located in the lower-rear of the chassis.
Step a
Step b
▄ Cisco ASR 5000 Series Aggregation Services Router Installation and Administration Guide
Remove the plastic bezel from the lower-front of the chassis by placing your fingers in the notches
Remove the fan tray cover by loosening the four screws that secure it in place using a #1 Phillips
Pull the fan tray toward you using the handle. The fan tray should easily slide out of the chassis.
W :
ARNING
To avoid personal injury and/or damage to the fan tray, be sure to support the fan tray's
Locate the PFU bay labeled Power Filter Unit 1 on the lower-left rear of the chassis.
Use a #2 Phillips screwdriver to loosen the four screws that secure the PFU in to the chassis.
Chassis Installation
OL-24878-01