Management Lan Interfaces; Console Port - Cisco ASR 5000 series Installation And Administration Manual

Aggregation services router
Hide thumbs Also See for ASR 5000 series:
Table of Contents

Advertisement

▀ ASR 5000 Line Cards
Number
Description
4
Optical Gigabit Ethernet Management LAN Interfaces—Two Small Form-factor Pluggable (SFP) optical Gigabit
Ethernet interfaces to connect optical transceivers.
5
10/100/1000 Mbps Ethernet Management LAN Interfaces—Two RJ-45 interfaces, supporting 10/100 Mbps or 1
Gbps Ethernet.
6
Console Port—RJ-45 interface used for local connectivity to the command line interface (CLI). See Cabling the Switch
Processor Input/Output Line Card for more information.
7
BITS Timing Interface—Either a BNC interface or 3-pin wire wrap connector. Used for application services that use
either the optical or channelized line cards.
8
CO Alarm Interface—Dry contact relay switches, allowing connectivity to central office, rack, or cabinet alarms. See
the Applying Power and Verifying Installation for more information.

Management LAN Interfaces

SPIO management LAN interfaces connect the system to the carrier's management network and subsequent
applications, normally located remotely in a Network Operations Center (NOC). You can use the RJ-45 10/100/1000
Mbps Ethernet interfaces or optical SFP Gigabit Ethernet interfaces.
When using the RJ-45 interfaces, CAT5 shielded twisted pair cabling is recommended.
Important:
from ESD or other transient voltage damage.
Table 10. SFP Interface Supported Cable Types
Module Type
Card
Identification
1000Base-
Ethernet 1000
SX
SX

Console Port

The console uses an RS-232 serial communications port to provide local management access to the command line
interface (CLI). A 9-pin-to-RJ-45 console cable is supplied with each SPIO card. The console cable must provide
carrier-detect when attached in a null modem configuration.
▄ Cisco ASR 5000 Series Aggregation Services Router Installation and Administration Guide
Use shielded cabling whenever possible to further protect the chassis and its installed components
Interface Type
Fiber, LC duplex female
connector
Cable Specifications
Fiber Type: Multi-mode fiber (MMF), 850 nm
wavelength
Core Size (microns)/Range:
62.5/902.23 feet (275 meters)
50/1640.42 feet (500 meters)
Minimum Tx Power: -9.5 dBm
Rx Sensitivity: -17 dBm
ASR 5000 Hardware Platform Overview
OL-24878-01

Advertisement

Table of Contents
loading

Table of Contents