Table of Contents
Advertisement
ASSEMBLY
Place all parts of the exercise bike in a cleared area
and remove the packing materials. Do not dispose
of the packing materials until assembly is completed.
Read all steps and examine all drawings carefully
before beginning.
1. Raise the back end of the exercise bike. Attach the Stabilizer
(13) to the Frame (11) with the two 5/16" x 1 1/4" Bolts (14).
The Stabilizer must be turned so the ribbed sides of the
Endcaps (12) are on the side shown. Lower the exercise bike.
2. Slide the free end of the Roller Axle (42) through the Bushings
(43) in the Frame (11). Press the unattached Roller (24) onto
the end of the Axle. It may be helpful to tap the Roller with a
hammer in order to press it fully onto the Axle.
3. Remove the four 1/4" Seat Nuts (7) from the underside of the
Seat (5). Remove the Seat Post (6) from the Frame (11). Attach
the Seat to the top of the Seat Post with the four 1/4" Seat Nuts.
Insert the Seat Post (6) into the Frame (11). Adjust the Seat (5)
to the desired height and insert the Seat Pin (8) through the front
of the Frame and the Seat Post. Slide the Seat Post Collar (30)
down over the Frame. CAUTION: At least two inches of the
Seat Post must be inside of the Frame. The Seat Pin must
be inserted from the front, as shown. If the Seat Pin is
inserted from the back, it may slip out.
In addition to the included tools, the following
tools are required for assembly:
one (1) hammer
one (1) adjustable wrench
1
14
12
2
24
3
30
8
12
11
13
11
43
42
5
7
7
6
11
5
Advertisement
Table of Contents
