Troubleshooting - Axis AX1513 Instruction Manual

TROUBLESHOOTING

Faults
No sound and image
No image
No sound
Black screen
Blurring and
unstable image
Poor colour
No power
No image after
loading the disc
Unstable sound
caused by vibration
Unstable sound even
with no vibaration
CAUTIONS
1. Do not expose the unit to rain, damp environments, dust and direct sunlight, or
excessive vibration.
2. Do not attempt to repair the unit by yourself. Please turn off and if any problems
arise, seek professional advice.
3. Do not use strong chemical cleaners when cleaning the unit. Please use a soft
damp cloth.
4. The unit storage temperature is from -20°C to 60°C. The operating temperature is
from -10°C to 60°C.
5. For your safety, please do not operate this monitor when driving as it is illegal in
most regions.
6. Safe power supply: DC12V (voltage range: 10V-14V)
Attention!
There may be some small bright spots appear on the screen. This is common technical matter with TFT pixels and does
not indicate a defect of this unit.
Power is disconnected; the machine is not turned on
Standby switch is pressed down; disc is scratched;
signal wire is disconnected
Volume too low or the volume setup is not workable;
No sound from Unit: Check if FM or IR transmit status has
been selected & turn OFF via IR or FM Mode in menu.
No sound from IR Headphones: Check if IR transmit
status has been selected & turn ON via IR Mode in menu.
Incorrect setup of image luminance and contrast;
under voltage
Disc is scratched
Function menu setup is incorrect; weak signal
Voltage is not correct; check interconnect circuit;
fuse is blown
Only audio frequency on the disc; disc is scratched;
disc format is not supported
DVD is dirty or seriously damaged
Disc is dirty or scratched; clean or replace the disc
7.
Possible Reasons