Cisco SX10 Quick Set Administrator's Manual page 16

Cisco TelePresence SX10 Quick Set

Introduction Introduction
How to administer the video system (page 4 of 4)
Settings available on the user interface
You have access to some basic configurations and system tests
on the video system's user interface. Some of the configurations
and tests may be unavailable due to the actual system setup.
• Change the language
• Change the time zone
• Adjust the screen (overscan compensation)
• Change the network settings for the video system
• Change the network settings for the Touch controller
• Select and activate a service (Cisco's cloud service, or Cisco
UCM, VCS or Expressway on-premise services)
• Check the microphone level
• Run a system volume check, and set the default volume
• Set the default camera position
• Check the connection to a presentation source
• View system diagnostics for troubleshooting
• Unpair the Touch controller from the video system, and select
another system to pair with
• Factory reset the video system
• Enable extended logging
Most of these settings and tests are also part of the Setup
assistant that is launched when the video system is powered up
for the first time. The Setup assistant is described in the Getting
Started Guide for systems running CE software.
D15330.06 SX10 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals
Access Settings
1. Select the settings icon (cogwheel) in the status bar of the
user interface.
2. Select System information >
You may set a PIN code to protect the Settings menu, refer to
► Set a PIN code for the Settings menu
the
3. Select the button next to the setting you want to change or
the test you want to run.
Maintenance
Settings.
chapter.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
16
Administrator Guide
System settings Appendices