Cisco SX10 Quick Set Administrator's Manual page 33

Cisco TelePresence SX10 Quick Set

Introduction
Set up Intelligent Proximity for content sharing
Enable Proximity services
1. Sign in to the web interface, and navigate to
Configuration.
2. Go to Proximity > Mode, and switch Proximity On.
The video system starts sending ultrasound pairing
messages.
3. Enable the services you want to allow. Only Wireless share
from a mobile device is enabled by default.
In order to fully utilise the Proximity functionality, we
recommend that you enable all services.
Place calls and control the video system:
• Go to Proximity > Services > CallControl
Enabled.
View shared content on a mobile device:
• Go to Proximity > Services > ContentShare > FromClients
and choose Enabled.
Wireless share from a desktop client:
• Go to Proximity > Services > ContentShare > ToClients
and choose Enabled.
D15330.06 SX10 Administrator Guide CE9.1, JUNE 2017.
Configuration Configuration Peripherals
Temporarily disable the Proximity services
Setup > In sessions or meetings where you want to prevent devices in the
room from receiving content, you can use the video system's user
interface to temporarily disable the Proximity services.
The video system will continue to transmit ultrasound
pairing messages during such sessions. This ensures that
clients will know about a nearby video system, and can
give the user an explanation why he cannot connect.
1. Select the settings icon (cogwheel) in the status bar of the
user interface to open the dropdown panel.
2. Switch Proximity on or off with the toggle button.
and choose
The Proximity indicator
You will see a Proximity indicator on the display when Proximity is
switched On, and at least one Proximity service is enabled.
The Proximity indicator has two states:
Proximity services are available for use.
Proximity services are temporarily disabled. Use the
toggle button in the settings dropdown panel to make
them available again.
Maintenance
(page 4 of 5)
33
Administrator Guide
System settings
About Proximity
The Proximity feature is switched Off by
default, because the use of third-party
speakers may need additional testing for
Proximity to work as expected. In rare
cases the ultrasound may cause audio
artifacts. If so, consider to decrease the
maximum ultrasound volume with the
Peripherals > Pairing > Ultrasound >
Volume > MaxLevel
When Proximity is switched On, the
video system transmits ultrasound pairing
messages.
The ultrasound pairing messages are
received by nearby devices with Proximity
clients, and triggers the authentication
and authorization of the device.
Provided that you have verified that
Proximity is suitable in your setup,
Cisco recommends - for the best user
experience - that Proximity always is
switched On .
*
In order to get full access to Proximity,
the Proximity services (Proximity >
Services > ...) must be Enabled as well.
SX10: We recommend not to use a headset, if
*
you have switched on Proximity (ultrasound).
SX10N: You can always use a headset.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Appendices
setting.