Returning To The Factory Settings (Factory Reset); Removing A Plug-Out (Plug-Out Remove) - Roland System-8 Reference Manual

1
Press the [MENU] button.
[ K ] [ J ]
2
Use the Cursor
[ENTER]
and then press the
The UTILITY screen appears.
UTILITY [Ent]
BACKUP
[ K ] [ J ]
3
Use the cursor
"EXCHANGE," and then press the
EXCHANGE [Ent]
SYS8: A-1 ÄÀ A-1
If you're exchanging patches, use the MODEL buttons to select the
model of patches that you want to exchange.
4
Use the [VALUE] knob and the cursor
to select the patches/performances that you want to
exchange.
5
Press the [ENTER] button.
A confirmation message appears.
Exchange?
[Exit]:N [Ent]:Y
6
To execute, press the
If you decide to cancel, press the
When the exchange is completed, the display indicates
"Completed!"
Completed!
NOTE
If you exchange a patch that is used by a performance, that
performance will no longer be reproduced.

Returning to the Factory Settings (FACTORY RESET)

1
Press the [MENU] button.
[ K ] [ J ]
2
Use the Cursor
and then press the [ENTER]
The UTILITY screen appears.
UTILITY [Ent]
BACKUP
[ K ] [ J ]
3
Use the cursor
RESET," and then press the
Sel Target [Ent]
ALL
buttons to select "UTILITY,"
button.
À
buttons to select
[ENTER] button.
[ K ] [ J ]
buttons
[ENTER] button.
[EXIT]
button.
buttons to select "UTILITY,"
button.
À
buttons to select "FACTORY
[ENTER] button.
4
Use the [VALUE] knob to select the item that you
want to factory-reset.
Item
Explanation
[VALUE]
knob
All of the SYSTEM-8's settings/patches/
ALL
performances, including PLUG-OUT 1–3, are
reset to their factory-set state.
Only the SYSTEM-8's settings/patches/
EXCEPT PLUG-
performances, and not PLUG-OUT 1–3, are
OUT
reset to their factory-set state.
SYSTEM-8 Only the SYSTEM-8's patches are reset to their
PATCH factory-set state.
PLUG-OUT 1
Only the patches of a synthesizer installed in
PLUG-OUT 2 PLUG-OUT 1–3 are reset to their factory-set
state.
PLUG-OUT 3
5
Press the [ENTER] button.
A confirmation message appears.
Factory Reset?
[Exit]:N [Ent]:Y
6
To execute, press the
If you decide to cancel, press the
When the factory reset is completed, the screen indicates
"Completed!"
Completed!
Turn off power.
7
Turn the power of the SYSTEM-8 off, then on again.

Removing a PLUG-OUT (PLUG-OUT REMOVE)

1
Press the [MENU] button.
[ K ] [ J ]
2
Use the Cursor
and then press the [ENTER]
The UTILITY screen appears.
[ K ] [ J ]
3
Use the cursor
REMOVE," and press the
If there are only the pre-load plug-outs, there are no plug-outs to
remove, so the display indicates
Empty!
Convenient Functions (UTILITY)
[ENTER] button.
[EXIT] button.
buttons to select "UTILITY,"
button.
buttons to select "PLUG-OUT
[ENTER] button.
"Empty!"
29