Specifying The Note Length Of One Step (Setting) - Roland System-8 Reference Manual

About the Step Sequencer
2
Use "From:" to select the copy-source patch
number, and press the
PTN COPY [Ent]
From:SYS8 A-1
3
At the confirmation screen, press the
button.
If you decide to cancel, press the

Specifying the Note Length of One Step (SETTING)

1
In the SEQ MENU screen, select
[ENTER]
the button.
SETUP:
Default Gate
2
"Default Gate"
Specify the
Value
Parameter
[VALUE]
Default Gate 1–100
* This parameter is initialized when you turn off the power (default
value: 50).
38
[ENTER]
button.
[ENTER]
[EXIT]
button.
"SETTING" and press
50
value.
Explanation
knob
Specifies the note length of
each step (default value: 50).
If this is 100, the note
continues sounding until the
end of the step.