Table of Contents
Advertisement
Performing Advanced Configuration
8. Click OK.
9. Enter the MAC Address that you wrote down in Step 2 in one of the Partner MAC Address field of the Wireless
Distribution Setup window.
10. Set the Status of the device to Enable.
11. Click OK
.
12. Reboot the AP.
Ethernet
Select the desired speed and transmission mode from the drop-down menu. Half-duplex means that only one side can
transmit at a time and full-duplex allows both sides to transmit. When set to auto-duplex, the AP negotiates with its
switch or hub to automatically select the highest throughput option supported by both sides.
For best results, Proxim recommends that you configure the Ethernet setting to match the speed and transmission
mode of the device the Access Point is connected to (such as a hub or switch). If in doubt, leave this setting at its
default, auto-speed-auto-duplex. Choose between:
•
10 Mbit/s - half duplex, full duplex, or auto duplex
•
100 Mbit/s - half duplex or full duplex
•
auto speed - half duplex or auto duplex
56
Advertisement
Table of Contents
