Table of Contents
Advertisement
Getting Started
Figure 2-5
Remove the Back Cover
7. Connect one end of an Ethernet cable to the Access Point's Ethernet port. The other end of the cable should not
be connected to another device until after the installation is complete.
•
Use a straight-through Ethernet cable if you intend to connect the Access Point to a hub, switch, patch panel,
or Active Ethernet power injector.
•
Use a cross-over Ethernet cable if you intend to connect the Access Point to a single computer.
8. If you are not using Active Ethernet (or you want to connect the Access Point to Active Ethernet and AC power
simultaneously), attach the AC power cable to the Access Point's power port.
Figure 2-6
Attach Ethernet Cable and Power Cable
Power Cable
Ethernet Cable
20
Advertisement
Table of Contents
