Table of Contents
Advertisement
Performing Advanced Configuration
•
Syslog Heartbeat Status: Enables or disables the sending of heartbeat messages from the AP to the configured
Syslog servers.
•
Syslog Heartbeat Interval: Specifies the interval (in seconds) at which Syslog Heartbeat messages are sent to
the configured Syslog servers.
•
Syslog Host Table: This table specifies the IP addresses of a network servers that the AP will send Syslog
messages to. Click Add to create a new entry. Click Edit to change an existing entry. Each entry contains the
following field:
–
IP Address: Enter the IP Address for the management host.
–
Comment: Enter an optional comment such as the host name.
–
Status: The entry is enabled automatically when saved (so the Status field is only visible when editing an
entry). Disable or delete entries by changing this field's value.
Syslog Messages
The following messages are supported in the AP:
Message
Auto Configuration via DHCP
Auto Configuration for static IP
TFTP server IP/Config filename missing in DHCP response
AutoConfig TFTP server IP address used is <IP address>
AutoConfig filename used is <filename>
AutoConfig TFTP download failed
Image Error check, invalid image
AP Heartbeat status
Client Authentication State
Accounting
RADIUS Responses
Severity
Informational
Informational
Minor
Informational
Informational
Minor
Minor
Minor
Informational
Informational
Informational
77
Advertisement
Table of Contents
