Table of Contents
Advertisement
[Assembling Procedures]
1. Reinstall the Stacker Unit by reversing the procedure above.
CAUTION:
When the Stacker Paper Exit Arm is in the position as that of the diagram below,
engage the gear so that the notch of the Belt Detection Gear actuator meets with the
edge of PS9 as per the diagram below.
Figure 6-43. Removal of the Stacker Unit
6-24
DDP70 Finisher Maintenance Manual
BELT DETECTION GEAR
STACKER PAPER EXIT ARM
ACTUATOR
PS9
ACTUATOR NOTCH
M M
L
0 0
Advertisement
Table of Contents
