Table of Contents
Advertisement
PRIMARY FACTOR;
E1D0: Paper did not arrive at the FIN Entrance Sensor.
E1D1: Paper did not arrive at the Paper Exit 2 Sensor.
E1D2: Paper did not arrive at the Stacker Conveyance Sensor.
E1D3: Paper did not arrive at the Paper Exit 1 Sensor.
E1D5: Paper did not depart from the Paper Exit 2 Sensor.
E1D6: Paper did not depart from the Stacker Conveyance Sensor.
E1D7: Paper did not depart from the Paper Exit 1 Sensor.
E1D8: Paper did not arrive at the Sub-Tray Paper Exit Sensor.
E1D9: Paper did not depart from the Sub-Tray Paper Exit Sensor.
1.
Paper jam occurs. 7.
8.
2.
The Sensor
1.
detected the jam
though a jam did
2.
not occur.
3.
5-14
DDP70 Finisher Maintenance Manual
Shift Unit fault.
Check if Paper jam
occurs at the Shift Unit on
offset mode
PCB fault.
The Sensor window is
contaminated.
The breaking of cables or
the disconnecting of
connectors.
Sensor fault.
Check points:
Check if the paper on
paper path error occurs
on initialization after
masking of the sensor
actuator.
Error codes when the
sensors are normal.
Sensor Name-Error Code
FIN Entrance Sensor-
E064
Paper Exit 1 Sensor-E065
Paper Exit 2 Sensor-E065
Stacker Conveyance
Sensor-E066
Sub-Tray Exit Sensor-
E068
Adjust: Shift position
Replace: FS-104H P/K
Cleaning: Sensor
Repair the cable or reset the
connector in the correct position.
E1D0:CN5-PS4
E1D1:CN11-PS23
E1D2:CN5-PS5
E1D3:CN5-PS6
E1D5:CN11-PS23
E1D6:CN5-PS5
E1D7:CN5-PS6
E1D8:CN5-PS1
E1D9:CN5-PS1
Replace: Sensor
Replace: FIN Entrance
Sensor (PS4)
Paper Exit 2 Sensor
(PS6)
Stacker Conveyance
Sensor (PS5)
Paper Exit 1 Sensor
(PS23)
Sub-Tray Exit
Sensor (PS1)
M M
L
6.7.4, 6-34
4.3.11, 4-16
3.5, 3-5
3.5, 3-5
3.5, 3-5
3.5, 3-5
3.5, 3-5
0 0
Advertisement
Table of Contents
