TESTO 570 Instruction Manual page 24

6 Using the product
24
Shop for Data Logging products online at:
Measurement period
(hhh:mm)
000:00...099:59
100:00...240:59
241:00...999:59
If the selected measurement duration is not a multiple of
the set measuring cycle, it is reduced to the next
possible measurement duration. In this case, the
instrument displays the automatically adjusted
measurement duration at the start of the measurement.
Measurements can be assigned to the individual categories
Customer, Measurement place, Installation and Component and
saved, already in the device.
In the device the following standard categories have been
pre-set: Customer
Component.
These categories can be changed (e.g. testo / Cellar 1 /
Office building 1 / Compressor) and supplemented via the
testo software Easy Kool, see separate operating
instructions.
Saving a single measurement
✓ The desired measuring mode has been selected.
1. Press [ ].
2. Select Single measurement.
3. Select Save.
4. Select the desired memory location: Press
the desired value and press
Customer / Measplace
- The set measurement view is displayed. The memory symbol
is displayed.
5. Press [Save].
- The memory symbol
measurement data have been saved.
Saving a serial measurement
Depending on the duration of the serial measurement
electric power supply via power supply unit may be
required.
www.
Minimum possible measuring cycle
2 seconds
10 seconds
30 seconds
/ Measplace /
[◄] and
/ Installation
flashes and disappears after the
DataLoggerStore
Installation /
[▲] and [▼] to set
[►] to toggle between
/ Component.
1.877.766.5412
.com