Led Status Signals - Ubisys G1 Assembly And Commissioning Instructions

Section 3 | Gateway G1 Configuration
Caution: Not all routers are able to establish a connection from the internal network, i.e. that your smartphone
is in your own Wi-Fi, via the public address, because port forwarding only works for external access. Exem-
plary for this behavior are the Fritzbox models of AVM and the Speedport of the Deutsche Telekom. Other
models, however, such as the Vodafone easybox are able to forward requests from the local network.
If your router is not able to forward internal requests, follow these steps:
1. Temporarily disable the Wi-Fi function of your smartphone.
2. In your smartphone app, tap the gateway and wait until connection has been established. If the gateway has
already been entered in the list, the second entry disappears. Instead, an entry with more than one address
will exist. If not, an access code is required.
3. Enable the Wi-Fi function of your smartphone. From now on, the app automatically establishes a connec-
tion to the gateway via one of the two addresses. Turning off the Wi-Fi function of your smartphone is not
necessary anymore.
Note: If you entered the public address first, you can determine the local address later by dragging down the
list (swipe gesture). The list of available gateways in the local network will then be refreshed by the integrated
support for Apple Bonjour. If both an external (Internet) and internal (Wi-Fi) address is found for a gateway,
both entries will automatically be combined and your Smart Home System reachable via Wi-Fi on site as well
as via mobile radio while being on the move.

3.11 LED status signals

The LED on the front of your gateway shows the current status of your Smart Home System. The following sta-
tus signals and error messages are defined:
Color Status
Green Constant
Orange Blinking
Orange & green Blinking alternately
Red Blinking
Red Permanent
Blue Flashing up
Blue Flashing
Gateway G1
Meaning
Everything ok
Warning
Updating
Error
Critical error
New update available
Add smartphone
What to do?
/
The status site on the configuration web interface
informs you about occurring warnings.
During the update process, power supply must not
be interrupted.
The status site on the configuration web interface
informs you about occurring errors.
A critical error occurred on your gateway. Please
contact the support.
A new update for your gateway is available. You can
install it via the configuration web interface of your
gateway.
The function "Adding a new control device" has
been activated via the configuration web interface
of your gateway. Enter the access code in the app
of the new control device to enable access via this
device.
45