Table of Contents
Advertisement
Section 3
| Gateway G1 Configuration
Error messages (red highlighted)
Content
Failed to initialize the Gateway Service.
If the error is not patched automatically after some time, restart
the gateway.
If the error still persists after the restart, contact the ubisys
support (http://www.ubisys.de/smarthome/support.html).
No ZigBee adapter found.
If the error is not patched automatically after some time, restart
the gateway.
If the error still persists after the restart, contact the ubisys
support (http://www.ubisys.de/smarthome/support.html).
The ZigBee adapter could not be started.
If the error is not patched automatically after some time, restart
the gateway.
If the error still persists after the restart, contact the ubisys
support (http://www.ubisys.de/smarthome/support.html).
Failed to initialize the gateway. Further attempts will follow.
The gateway is temporarily not available. Further attempts will
follow.
The component (IEEE address: 00:1F:EE:00:00:00:00:01)
does not respond to configuration attempts. Further attempts
will follow.
3.2 Basic settings
The basic settings are used for general configuration of your gateway:
3.2.1 Device information
Device information can be freely defined. In environments with several gateways, it helps identifying every single
device. Your defined description of the gateway can also be found, for example, in the ubisys Smart Home app.
To make your individual information, follow these steps:
1.
Click the "Edit" button (see figure 15).
2.
Select the textbox you wish to edit.
3.
Fill in your information.
Gateway G1
Explanation
An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the ubisys support.
An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the ubisys support.
An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the ubisys support.
An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the ubisys support.
During operation, an error occurred in the integrated ZigBee
adapter of the gateway. . This is an internal error, which should not
occur in general. Restart the gateway. If the error occurs repeated-
ly, contact the ubisys support.
This could be a temporary radio transmission interference in the
Smart Home facility, wherein a configuration command could not
be sent to a target device or acknowledged.
This error can be caused by external parasitic induction, an inac-
tive ZigBee router or a deactivated target device and is usually
automatically fixed, as soon as the affected device is online or the
error source has been disabled.
If this error occurs repeatedly, check if the affected device and
temporarily stored ZigBee routers are installed and properly
connected to power. If the problem still exists, contact the ubisys
support.
18
Advertisement
Table of Contents
