Table of Contents
Advertisement
Section 3
| Gateway G1 Configuration
3.9 Change network parameters for gateway access
Configuration of your Smart Home gateway is done via a web interface in your browser. By default, the gateway
has the address 192.168.0.211. If you use another IP subnet in your local network (home or office network), the
gateway will not be reachable.
To adjust the network settings of your gateway and configure it, these steps have to be done:
1.
Connect the gateway to a PC or laptop via network cable.
2.
Change the IP address of the PC.
3.
Adjust network settings of the gateway to the home network.
4.
Change the IP address of the PC to its old one.
5.
Connect gateway to the home network via cable.
For this, follow these steps:
3.9.1 Connect gateway to PC
Connect your gateway to a PC or laptop via the included network cable (see figure).
A PC/Laptop
B Network Cable
C Gateway G1
3.9.2 Change the IP address of your PC
By default, your gateway has the address 192.168.0.211. In order to reach the gateway via this address, the IP
address of your PC has to start with 192.168.0. To change the IP address of your PC, follow these steps:
Windows XP/Vista/7/8
1.
Click on Start -> Control Panel -> Network and Internet -> Network and Sharing Center.
2.
Click on "LAN Connection" (see figure 58). The name may be different on your PC. If your PC has several
network adapters, select the one that is connected to the gateway.
Gateway G1
D Power Adapter
E Power Socket
36
Advertisement
Table of Contents
