Description And Operation; Fuel Injection System Component Location - Audi A6 Repair Manual

Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
2

Description and Operation

⇒ "2.1 Fuel Injection System Component Location", page 6
⇒ "2.2 Air Filter Assembly Overview", page 15
⇒ "2.3 Upper Intake Manifold Assembly Overview", page 16
⇒ "2.4 Lower Intake Manifold Assembly Overview", page 18
2.1

Fuel Injection System Component Location

Engine Compartment, Right
1 - Right electro-hydraulic en‐
gine mount solenoid valve -
N145-
❑ Component location
⇒ page 13
2 - Intake air switch-over valve
-N335-
❑ Component location
⇒ page 14
3 - Camshaft Position (CMP)
sensor 3 -G300-
❑ Component location
⇒ page 12
4 - Oxygen sensor -G39-
❑ Component location
⇒ page 11
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
❑ Connector location
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
⇒ page 10
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Removing and installing
⇒ page 44 .
5 - Oxygen Sensor (O2S) be‐
hind Three Way Catalytic Con‐
verter (TWC) -G130-
❑ Component location
⇒ page 11
❑ Connector location
⇒ page 10
❑ Removing and installing
⇒ page 47 .
6 - SIMOS control module -
J361-
❑ Component location
⇒ page 9
❑ Removing and installing
❑ After replacement, adapt throttle valve control module in operating mode "Guided Fault-Finding" in
"Adapting throttle valve control module"
❑ After replacement on vehicles with automatic transmissions, also perform kick-down adaptation in op‐
erating mode "Guided Fault-Finding" in "Kick-down adaptation"
7 - Right holder for connectors
❑ Connector locations
8 - Camshaft adjustment valve 1 (exhaust) -N318-
❑ Component location
6
Rep. Gr.24 - Fuel injection system
⇒ page 41 .
⇒ page 10
⇒ page 12