Audi A6 Repair Manual page 62

2005 year; fuel injection and ignition
Hide thumbs Also See for A6:
Table of Contents

Advertisement

Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
– Disconnect check valve -1- from air duct hose.
– Remove air duct hose, thereby loosening hose clamp -2- and
opening clips -arrows-.
– Disconnect electrical connectors at Engine Coolant Temper‐
ature (ECT) sensor -G62- -1- and Intake manifold flap change
over valve -N239- -2-.
Note
Ignore -3 -.
– Disconnect electrical harness connectors.
1 -
Camshaft adjustment valve 1 (exhaust) -N318-
2 -
Camshaft adjustment valve 1 -N205-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
3 -
Camshaft Position (CMP) sensor -G40-
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
4 -
Intake manifold runner position sensor -G336-
5 -
Camshaft Position (CMP) sensor 3 -G300-
– Remove bolts -arrows- and disconnect electrical connections
at ignition coils.
– Set electrical wiring harness aside.
Cylinder Bank 2 (Left)
– Remove coolant expansion tank -arrow-.
– Disconnect electrical connection from Engine Coolant Level
(ECL) warning switch -F66- at bottom of coolant reservoir and
set aside coolant reservoir with coolant hoses -1- and -2- con‐
nected.
58
Rep. Gr.28 - Ignition system
with respect to the correctness of information in this document. Copyright by AUDI AG.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents