Audi A6 Repair Manual page 11

9 - Camshaft adjustment valve 1 -N205-
❑ Component location
10 - Throttle valve control module -J338-
❑ After replacement, adapt in operating mode "Guided Fault-Finding" in "Adapting throttle valve control
module"
11 - Evaporative emission (EVAP) canister purge solenoid valve -N80-
12 - Intake Air Temperature (IAT) sensor -G42- / Manifold Absolute Pressure (MAP) sensor -G71-
❑ Component location
13 - Intake Manifold Runner Control (IMRC) valve -N316-
Component location ⇒ page 13
14 - Knock sensor 1 -G61- 20 Nm
❑ Component location
❑ Connector location
15 - Intake Manifold Tuning (IMT) valve position sensor -G513-
❑ Component location
16 - Change over valve for intake manifold flap -N239-
❑ Component location
17 - Engine Coolant Temperature (ECT) sensor -G62-
❑ Component location
18 - Actuator for intake manifold change over
19 - Intake manifold runner position sensor -G336-
❑ Component location
❑ After replacing, adapt in "Guided Fault Finding" operating mode under "Adapting intake manifold runner
position sensor"
20 - Fuel injectors, cylinder bank 1
❑ Cylinder 1 fuel injector -N30-
❑ Cylinder 2 fuel injector -N31-
❑ Cylinder 3 fuel injector -N32-
❑ Removing and installing
21 - Camshaft Position (CMP) sensor -G40-
❑ Component location
22 - Ignition coils, cylinder bank 1
❑ Ignition coil 1 with power output stage -N70-
❑ Ignition coil 2 with power output stage -N127-
❑ Ignition coil 3 with power output stage -N291-
❑ Removing and installing
Engine Compartment, Left
⇒ page 12
⇒ page 13
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 14
⇒ page 12
⇒ page 12
⇒ page 12
⇒ page 12
⇒ page 14
⇒ page 35 .
⇒ page 12
⇒ page 57 .
Fuel Injection and Ignition - Edition 03.2008
Audi A6 2005 ➤
2. Description and Operation
7