Audi A6 Repair Manual page 41

– Clip radial adjustment -1- to support ring -2-.
– When reinstalling a fuel injector, use a clean cloth to clean
combustion residue from groove for combustion chamber seal
and shaft of fuel injector.
– Place assembly cone -T10133/5- with new combustion cham‐
ber seal -1- on fuel injector -2-.
– Slide combustion chamber seal as far possible onto assembly
cone -T10133/5- using assembly sleeve -T10133/6- .
– Turn assembly sleeve -T10133/6- around and slide combus‐
tion chamber seal into groove.
Note
When pushing the combustion chamber seal onto the fuel injec‐
tor, the seal spreads open. Therefore after pushing it on, it must
be tightened again in 2 steps, as follows.
– Press sizing sleeve -T10133/7- with a slight turning motion
(approximately 180 degrees) onto fuel injector until it stops.
– Pull sizing sleeve -T10133/7- off again, turning it in opposite
direction.
Fuel Injection and Ignition - Edition 03.2008
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi A6 2005 ➤
5. Removal and Installation
37