Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
– Disconnect electrical connectors -1- and -2-.
Note
-1- depending on version
– Remove bolts -arrows-.
– Carefully lift high pressure lines.
Note
Do not change bend shape.
– Remove high pressure pump with actuator.
Installing
Installation is in reverse order of removal, note the following:
Note
Replace O-ring.
– To set high pressure pump in place, lift high pressure lines only
slightly.
Note
High pressure line connections must not show any signs of
♦
damage.
Do not change bend shape of high pressure lines.
♦
– Place high pressure pump with actuator into cylinder head and
fasten.
– Hand-tighten union nuts for high-pressure lines.
– Make sure high-pressure lines are seated free of stress.
– To fasten high-pressure line (14 mm) at high pressure pump
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
use torque wrench -V.A.G 1331- with ratchet -V.A.G 1331/1-
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
and socket 14 mm -3150- .
with respect to the correctness of information in this document. Copyright by AUDI AG.
40
Rep. Gr.24 - Fuel injection system