Audi A6 Repair Manual page 26

Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
– Remove cover for right locking flange -arrows-.
– Carefully release and disconnect electrical harness connector
-arrow- at locking flange.
Continuation for All
– Connect remote control -V.A.G 1348/3A- with adapter cable -
V.A.G 1348/3-3- with an adapter cable from connector test set
-V.A.G 1594C- at terminal -5-.
– Cover 2nd connector terminal of adapter cable -
V.A.G 1348/3-3- with insulating tape to prevent short circuit
-arrow-.
– Route remote control -V.A.G 1348/3A- switch forward in en‐
gine compartment.
– Connect alligator clip to ground (GND) point in engine com‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
partment.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Connect contact -1- to battery "+" using a self-made adapter
cable.
Note
For safety reasons, install a fuse -A- in the cable.
– Remove rear engine cover -arrows-.
WARNING
♦ Fuel system is under high pressure! Before opening high
pressure components of the fuel injection system, pressure
must be relieved to residual pressure
♦ Then wrap a clean cloth around the connection and relieve
residual pressure by carefully loosening the connection.
22
Rep. Gr.24 - Fuel injection system
⇒ page 2 .