Service Data - Zanussi ZCI660MBC User Manual

Problem
The sensor fields become hot.
comes on the hob display.
comes on the hob display.
comes on the hob display.
comes on the hob display.
comes on the hob display.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation settle
on the food and in the cavity of
the oven.

SERVICE DATA

If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The cookware is too large or
you put it too near to the con-
trols.
Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom of
the cookware is too small for
the zone.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The lamp is defective.
There was a power cut.
You left the dish in the oven for
too long.
We recommend that you write the data here:
Put large cookware on the rear
zones if possible.
Deactivate the hob and acti-
vate it again.
Refer to "Hob - Daily use"
chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hob - Hints and tips"
chapter.
Use cookware with correct di-
mensions.
Refer to "Hob - Hints and tips"
chapter.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
the appliance cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
.........................................
.........................................
Remedy
23