Table of Contents
Advertisement
Problem
The oven does not heat up.
Turnspits do not rotate.
Turnspits do not rotate.
It takes too long to cook the
dishes or they cook too quickly.
The display shows an error
code that is not in this table.
The display shows "12.00".
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
INSTALLATION
WARNING! Refer to Safety chapters.
LOCATION OF THE APPLIANCE
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
Possible cause
The necessary settings are not
set.
There is too much food on the
spits.
Connection spit is not installed
properly.
The temperature is too low or
too high.
There is an electrical fault.
There was a power cut.
We recommend that you write the data here:
Make sure that the settings are
correct.
Check the maximum weight
per each spit. Refer to "Oven -
Hints and tips" chapter, Cook-
ing tables.
Make sure that the shelf is
pushed till the end and the
connection spit is not protrud-
ing from its hole.
Adjust the temperature if nec-
essary. Follow the advice in the
user manual.
Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
Reset the clock.
the oven cavity. Do not remove the rating plate from
the oven cavity.
.........................................
.........................................
.........................................
For minimal distances for fitting check the table.
Remedy
23
Advertisement
Table of Contents
