Table of Contents
Advertisement
Problem
There is no good cooking per-
formance using the Plus Steam
function.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
the appliance cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.)
ENERGY EFFICIENCY
PRODUCT INFORMATION ACCORDING TO EU AND UK ECODESIGN REGULATIONS FOR
HOB
Model identification
Type of hob
Number of cooking zones
Heating technology
Diameter of circular cooking
zones (Ø)
Energy consumption per cooking
zone (EC electric cooking)
Possible cause
You did not fill the cavity em-
bossment with water.
The temperature is too low.
There is to much water in the
cavity embossment.
.......................................
..
ZCI69080XE
Hob inside Freestanding Cooker
4
Induction
Left front
Left rear
Right front
Right rear
Left front
Left rear
Right front
Right rear
Refer to "Activating the Plus
Steam function".
Set the temperature at least to
110°C. Refer to "Oven - Hints
and tips" chapter.
Deactivate the oven and make
sure that the appliance is cold.
Wipe the water with a cloth or
sponge. Add the correct
amount of water to the cavity
embossment. Refer to "Activat-
ing the Plus Steam function".
We recommend that you write the data here:
Product number
(PNC)
Serial number (S.N.)
21.0 cm
14.0 cm
18.0 cm
18.0 cm
178.0 Wh/kg
179.0 Wh/kg
181.0 Wh/kg
181.0 Wh/kg
Remedy
.......................................
..
.......................................
..
31
Advertisement
Table of Contents
