Table of Contents
Advertisement
3. Install the anti-tilt protection (A) approximately
77 mm below the top surface of the appliance
and 50 mm from the left or right side of the
appliance into the circular hole on the bracket.
Screw it into the wall.
4. Check that the anti-tilt protection (A) fits
minimum 20 mm into the hole in the rear wall of
the appliance (B) when you push the appliance.
ELECTRICAL INSTALLATION
WARNING! The manufacturer is not
responsible if you do not follow the
safety precautions from Safety
chapters.
This appliance is supplied without a main plug or a
main cable.
COVERING TERMINAL BOARD
ENERGY EFFICIENCY
PRODUCT INFORMATION FOR HOB ACCORDING TO EU 66/2014
Model identification
Type of hob
Number of cooking zones
Heating technology
Diameter of circular cooking
zones (Ø)
•
•
50 mm
•
77 mm
A
TERMINAL BOARD
Make sure that the links are fitted as shown.
ZCI660MBC
ZCI660MWC
Hob inside Freestanding Cooker
4
Induction
Left front
Left rear
Right front
Right rear
The recommended cross-section area is six
square millimetres (6 mm²).
When you refit the mains terminal cover, make
sure that the lower tabs are located inside the
bottom edge of the aperture, before you fix the
two screws into the top edge of the mains
terminal cover.
Make sure that the cover is securely fastened.
To open the cover of terminal board
obey the procedure in opposite
sequence.
Do not remove blanking plates.
L
L
N
N
N
21.0 cm
14.0 cm
18.0 cm
18.0 cm
25
Advertisement
Table of Contents
