Programme Selection - Miele Allerwash W 2584 WPS Operating Instructions Manual

Programme selection

To add detergent with the help of the
dispensing recommendation feature,
follow steps 2, 3 and 4 below before
loading the drum.
B Switch on the washing machine
^ Press in the I-On/0-Off button.
C Open the drum door
^ Press the Door button and open the
drum door.
The washing machine is switched on. If
the programme selector is at Finish , the
light ring around the programme
selector will flash to remind you to
select the programme required.
D Select a programme
^ Turn the programme selector to the
required programme.
The Load % indicator light will come on.
As the drum is empty, the display will
not yet show any number.
If a number is showing in the display
and the drum is empty, rotate the
drum once. If the display still shows
a number after rotating the drum
once, press the button above the
Start button until an audible tone
sounds.
Garment care label symbols
E Load the laundry
^ Unfold the laundry and load loosely
in the drum. Mixing both large and
small items gives better wash results
and also helps distribute the load
evenly during spinning.
The display shows the amount of
laundry loaded in the drum as a % (in
25% steps) of the maximum load
permissible for the programme
selected.
– Loads of less than 25% will not
register in the display.
– If the amount of laundry exceeds the
maximum load (100%), the value
shown in the display will flash to
indicate overloading. (Except with
Hygiene + and Cottons Universal
programmes).
Overloading causes creases and
reduces cleaning efficiency.
F Close the drum door with a firm
swing.
Make sure that no garments are caught
between the drum door and seal.
The Detergent % indicator light comes
on and the amount of detergent
required for the programme selected is
shown in the display.
23