Connection To The Water Supply - Miele Allerwash W 2584 WPS Operating Instructions Manual

Connection to the water supply

,
The plastic casing of the safety
valve contains electrical
components. The Waterproof system
must only be connected to its own
stopcock. It must not be connected
to mixer taps or similar and must not
be fitted in areas where there is the
risk of water or other liquids
reaching it.
Do not get wet.
The protective sleeve of the hose
must not be damaged or kinked.
Installation and connection
The machine should be connected to a
mains water supply in accordance with
local and national safety regulations.
The German authorities do not require it
to have a non-return valve as the
washing machine has been designed
to comply with DIN regulations.
The machine is designed to operate
with a flow pressure of between 100
and 1,000 kPa. If it is higher than
1,000 kPa it is essential to fit a reducer
valve.
Connection to the mains water supply
should incorporate a mains stopcock
3
with / " thread. The stopcock should
4
be fitted by a qualified plumber.
,
The connection point is subject
to mains water pressure. Turn on the
stopcock slowly and check for leaks.
Correct the position of the washer
and union if appropriate.
The washing machine is not suitable
for connection to a hot water supply
and connection to a household
water softener is not recommended.
57