Miele Allerwash W 2584 WPS Operating Instructions Manual page 24

Garment care label symbols
G Add detergent.
The percentage amounts in the display
help you to add the correct percentage
amount of detergent recommended by
the detergent manufacturer.
If the display shows:
40 Add 40 percent . . .
(slightly less than half)
50 Add 50 percent . . .
(half)
60 Add 60 percent . . .
(slightly more than half)
75 Add 75 percent . . .
(three quarters)
100 Add 100 percent . . .
. . . of the amount recommended by
the manufacturer.
Take the level of soiling and also the
water hardness into account. It is
important to dispense the correct
amount because . . .
. . . too much detergent results in:
– Excessive foam, which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an
additional rinse cycle will
automatically switch in).
– A burden to the environment.
24
^ Pull out the detergent drawer and
add detergent to the compartments
as follows:
i = Detergent for pre-wash
(if selecting a pre-wash add
of the total amount recom-
mended) This compartment is
also used for starch formula-
tions when starching separately.
j = Detergent for the main wash
including Soak.
§
= Fabric conditioner or liquid
starch.
See "Detergent" section for further
information.
1
/
4