Temperature Remote Controller; Included Accessories; Installation - Takagi 540P Indoor Installation Manual And Owner's Manual

TEMPERATURE REMOTE CONTROLLER

-Included accessories - Outdoor model only
• The remote control is an optional accessory that can be installed in a hall, closet, etc., to allow for
temperature adjustment without having to go to the heater.
• When installed, the remote will take priority over the built-in controller of indoor models.
Verify that the items listed below are included with the remote controller.
Temperature
remote controller
Qty: 1
100276687 (TM-RE43)
It is also an optional accessory as a second remote for the indoor model. Refer to pp. 9 and 10.
*The optional remote controller (100276687/TM-RE43) has no remote controller cable.
• This remote controller is NOT waterproof.
• The water heater can only have one remote controller.
• Do not install in high temperature environments, high humidity conditions outdoors, in
direct sunlight, or within the reach of children.
WARNING
• Make sure the remote controller does not come into contact with water or oil.
• Failure to observe these warnings could result in personal injury or electrical shock.
• Do not place the remote controller cable close to other wires from other products.
NOTICE
• Cables used for the remote controller connection must be:
•
•
<Mounting and Wiring the Remote Controller>
Take the Frame off of the remote controller with a flat head screwdriver. (Fig. A and B)
1.
Attach the Metal plate on the wall with two provided screws. (Fig. B)
2.
If you use another cable, crimp the Fork terminals to the wires. (Fig. C)
3.
Fig. A
Twist
Press and twist flat
head screwdriver
against the cutout.
Fig. C 1-3/8 Inch
(35 mm)
1-5/8 Inch
(41 mm)
Remote controller cable
Screws
Qty: 2

-Installation-

Minimum 20 gauge wire (No polarity)
Maximum 400 ft (122 m) long
Fig. B
Attached short screws
Main unit
Frame
Fork
Terminals Cut out (removed during later steps).
38
Fork terminals Manual
Qty: 1
Qty: 4
Metal plate
B
Hook B to the Fixing
bracket on A.
Page
Installation Manual
Installation
Remote controller
cable*
Qty: 1
3-1/4 inch
(83.5 mm)
A
A + B