TEMPERATURE REMOTE CONTROLLER
-Included Accessories-Outdoor models only-
Check that these items below are included with the remote controller.
Temperature
remote controller*
Qty: 1
9009069005 (TM-RE42)
*
It is also an optional accessory as a second remote for the indoor models. The optional remote con-
troller doesn't come with the remote cable. Refer to p. 9.
This remote controller is NOT waterproof.
The water heater can only have one remote controller at a time.
Do not install in high temperature environments, high humidity conditions out-
doors, in direct sunlight, or within the reach of children.
CAUTION
Make sure the remote controller does not come into contact with water or oil.
• Do not place the remote control wiring close to other wires from other
• Do not extend the remote control wiring more than 400 ft. (122 m.)
Mounting and wiring the remote controller
1. Take off the "Back plate" from the remote controller with a flat head screwdriver. (Fig. A and B)
2. Attach the "Back plate" on the wall with the two provided screws. (Fig. B)
Fig. A
Twist
Screws
Qty: 2
-Installation-
products.
Press and twist flat head
screwdriver against the cutout.
Main body
Fig. B
Attach the screws
Main body
30
Page
Installation Manual
Manual
Remote controller cable
Qty: 1
Back plate
Cut out the partition with pliers
Installation
Qty: 1
3-1/4 inches