Setting The Clock Time; Radio Operation - Jensen JCR-228 User Manual

In order for the clock to function properly, the clock has to be set before you use it for
the first time. After powering up the unit or press and hold PRESET/TIME Button (#7)
at standby mode, the clock display will flash. To set the time, follow the steps below:
1. Tap the TUN-/HR/
displayed..
2. Press the PRESET/TIME Button (#7) to confirm the time.
Note:
Make sure the hour is set so that AM or PM is correctly displayed. There is a PM
INDICATOR (#14) located in the upper left corner of the LED display. If the PM
INDICATOR (#14) is showing on the display, the displayed time is "PM". If the PM
INDICATOR (#14) is not showing on the display, the time displayed is "AM".
Press the MODE /
Mode, frequency will show on the LED display.
Press and hold the TUN-/HR/
for the next / previous available station. If the reception is poor, try Manual Tuning to
fine-tune the station. Tap the TUN-/HR/
briefly to manually tune through the frequency band.
Adjust the VOLUME +/- Control (#9/10) to obtain the desired sound level.
The LED display will change to show the clock time after a few seconds. Press the
TUN-/HR/
OR TUN+/MIN/
Setting the Radio Station Presets
The unit allows you to store up to
at any time.
1. Press the POWER /
AM/FM Mode.
2. Tune to the radio station you want to store in memory.
3. Press and hold the PRESET/TIME Button (#7). The preset channel number "P01"
will be flashing on
4. To change the preset channel number location,
Buttons (#3/4) to step through the preset locations ( P01 – P30 ).
TUN+/MIN/
5. To confirm the preset location, press
6. To store up to 30 station presets, repeat steps 2-5 above.
RECALL PRESET STATION
In AM/FM mode, press PRESET/TIME Button (#7) repeatedly to select the preset
channel.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change the
position of the unit until the internal antenna picks up the strongest signal.
FM - If FM reception is weak, fully extend the wire antenna and vary the position and
location of the antenna until you find the strongest signal.

SETTING THE CLOCK TIME

/ TUN+/MIN/ Buttons (#3/#4) until the correct time is

RADIO OPERATION

Button (#6) repeatedly to Turn On the unit and select AM/FM
Button (#3) OR TUN+/MIN/
Buttons (#3/4) to check the tuned frequency.
30 FM stations and 30 AM stations for easy recall
Button (#6) repeatedly to Turn On the unit and select
display.
PRESET/TIME Button (#7).
E-7
Button (#3) OR TUN+/MIN/
press the TUN-/HR/
Button (#4) to search
Button (#4)
OR