Standby Mode; Setting The Time - Jensen JCR-255 User Manual

3. Do not mix old and new batteries.
4. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
5. If the unit is not to be used for an extended period of time, remove the batteries.
Old or leaking batteries can cause damage to the unit and may void the warranty.
6. Do not try to recharge batteries not intended to be recharged; they can overheat
and rupture. (Follow battery manufacturer's directions).
7. Do not dispose of batteries in fire, batteries may leak or explode.
IMPORTANT: LED DISPLAY DIMMER CONTROL
If the LED display is OFF or very dim when you first plug the unit it, you will need to
adjust the ROTARY DIMMER CONTROL (#20) located on the back of the unit.
Rotate the ROTARY DIMMER CONTROL (#20) to set the brightness of the display
before proceeding. You can readjust the dimmer control later to make it brighter or
dimmer if needed.
Standby Mode is when the unit is first plugged into an AC power source (display
flashing), or after all the settings have been made and the time is showing on the
display. The radio is off, no buttons are pressed and no alarms are sounding.
The display will be flashing when the unit is plugged in for the first time. Tap the TIME
SET BUTTON (#14) to go to the Time Set Mode.

Setting the Time

1. In standby mode, Press
clock display begins to flash.
2. Repeatedly tap the
hour. Press and hold the buttons for fast advance/reverse setting. Make sure the
correct AM or PM time is selected when setting the hour.
Note: The PM INDICATOR (#10) is located in the lower part of the display and
centered below the " : " that separates the hour digits from the minute digits. The
PM INDICATOR (#10) will light when the hour digits selected are for PM time. The
PM INDICATOR (#10) will be off when the hour digits selected are for AM time.
3. Tap the TIME SET
blink.
4. Repeatedly tap the
minute. Press and hold the buttons for fast advance/reverse setting.
5. Tap the TIME SET
display will stop blinking.
Note: The unit will automatically save the settings and exit the time set mode if you do
not press any buttons within 10 seconds.

STANDBY MODE

SETTING THE TIME
the TIME SET BUTTON (#14)
UP BUTTON ( #19) or
BUTTON (#14) to confirm the time and the minute digits will
UP BUTTON ( #19) or
BUTTON (#14) to confirm and complete the time setting. The
E-8
until the hour digits of the
DOWN BUTTON (#11) to set the
DOWN BUTTON (#11) to set the