Access Point Mode; Repeater/Bridge Mode - TP-Link TL-MR3020 User Manual

Chapter 2
2. 2. 4.

Access Point Mode

Create a wireless network from an Ethernet connection. This mode is suitable for
dorm rooms or homes where there's already a wired router but you need a wireless
connection.
1. Switch the operation mode to
2. Connect your device to the router wirelessly. The SSID (wireless network name) and
password are on the router's label.
Internet
Wired Router
A
2. 2. 5.

Repeater/Bridge Mode

Repeat signal from an existing wireless network. This mode is suitable to extend
wireless coverage, reaching devices that were previously too far from your host router
to maintain stable wireless connection.
1. Switch the operation mode to
B.
2. Connect your device to the router wirelessly or via an Ethernet cable. The SSID
(wireless network name) and password are on the router's label.
Internet
Host Router
AP and connect the hardware according to Step A to D.
B
C
AP and connect the hardware according to Step A and
A
Connect the Hardware
D
B
8